Need Help! Mazak EIA porgram for Thread Milling - CNCzone.com-The Largest Machinist Community on the net!

07-12-2010, 03:51 PM

spikey99

Join Date: Jul 2010

Location: England

Posts: 1

Mazak EIA porgram for Thread Milling

permalink

Hi, we have an Integrex with the old T-Plus control and would like to Thread Mill using an EIA program. We do run thread milling progs on Fanuc controls ok but not on the mazatrol. I can only assume it is down to the G-code etc. Can anyone post a proven program please. This could end many days of severe frusssssttttttrrrrrrraaaaaaaaation.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mazak Thread milling	KBHone	Mazak, Mitsubishi, Mazatrol	3	03-31-2012 06:22 PM
Need Help!- thread chasing on mazak slantbed	tazman2221	Mazak, Mitsubishi, Mazatrol	5	04-22-2009 09:32 AM
Mazak 640 outside thread milling	petrman	Mazak, Mitsubishi, Mazatrol	6	01-09-2009 05:46 PM
Maho copyring in the porgram	Muerto	Deckel, Maho, Aciera, Abene Mills	0	07-26-2008 09:14 AM
Need Help!- Thread shattering on Mazak Intergrex 40	Marcial	Mazak, Mitsubishi, Mazatrol	3	03-01-2008 11:33 AM

All times are GMT -5. The time now is 12:09 AM.