Problem- Mazatrol m2 runs only 9999 blocks

[sve0019]

Can somebody answer if mazatrol cam m2
in ISO mode is able to run more then 9999 blocks,
and in case how?

Thank you
Sven.

[dcoupar]

I would assume it will only display N4 digits, but will run a program over 9999 blocks. Can you remove the N numbers from your program? In most cases they just use up memory.

[sve0019]

Its not that,it is the problem then you have more then four digits
like N10001 it will stop and saying nummerical is out off range.
Sven

[Torsten]

Originally Posted by sve0019 Its not that,it is the problem then you have more then four digits like N10001 it will stop and saying nummerical is out off range. Sven

I belive this can be set at the Cam Post to use only 4 digit numbers, it will then just start the count over with N0001 and continue.
Of cause you could just simply get rid of the numbers too.

[dcoupar]

Originally Posted by sve0019 Its not that,it is the problem then you have more then four digits like N10001 it will stop and saying nummerical is out off range. Sven

As I said, why not remove the N numbers, or just number the tool changes or as Torsten suggests if your CAM system will do it, limit your N numbers to 4 digits.

[sve0019]

In the postprocessor I was setting sequence numbers to four,
and N numbers to N like no.

With thanks from Sven for helping out.
End off problem.