MItsuibishi servo drive MDS-A-SVJ

[Pass002]

I need help in my CNC machine one of the axis drive make Mitsuibishi type MDS-A-SVJ is showing error message 10 what it indicates? Any body know about this ? From where can I download the manual so that such error messages can be find out. Please reply urgently

Pass002

[Al_The_Man]

Not sure whether you can access it from India, MEAU is the Mitsubishi site, some countries have a problem getting access.
Al.

[Pass002]

Thanks for prompt & early reply I will try out your suggested site

Pass002

[onthebumper]

Alarm ten is under voltage. Check the incoming power to the drive to make sure you have good power going to it. Check R,S, and T. You should have between 200 and 230 AC volts. If you do then the drive will need to be repaired or replaced.

[Pass002]

Dear onthebumper

Thanx for the message You are absolutely right. There is resistor value 3J 25W was faulty Which was replaced and drive starts working

pass002