How to restore tool magazine on Meldas? - CNCzone.com-The Largest Machinist Community on the net!

06-06-2010, 03:54 PM

smirob

Join Date: Mar 2003

Posts: 39

How to restore tool magazine on Meldas?

permalink

Hello all,

I did something that caused my Mighty Comet with an Meldas M2 control to get confused and now the tools are all 2 tools off. In other words when I call up M6 T5, Tool 7 is pulled from the magazine. If I do an M6 T11, then Tool 13 is pulled.

Not sure what I did, other than to say I tried a warm-up routine someone had written for a HAAS mill on my machine. I'm hoping someone can point me to somewhere in the control that I may be able to reset it to factory defaults.

Thanks in advance,
Rob, MI

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Tool magazine stuck (AL 212), integrex 400IV Matrix	-PC-	Mazak, Mitsubishi, Mazatrol	9	02-01-2010 09:43 AM
Need Help!- the magazine don't rotary when to change tool	Vu Tri Nhat	Servo Drives	2	11-30-2008 03:07 AM
Tool Height not consistent - Meldas M50	avongil	Mazak, Mitsubishi, Mazatrol	7	10-12-2008 03:38 PM
Random tool magazine to initial state?	padobranac	Fanuc	7	10-03-2008 02:11 PM
How to do Tool Changing on Mits MV-70E w/ Meldas 520	icnc	Mazak, Mitsubishi, Mazatrol	0	06-26-2007 11:30 AM

All times are GMT -5. The time now is 03:31 PM.