Need Help! post for t-2 controller - CNCzone.com-The Largest Machinist Community on the net!

tward74 · #1 03-20-2010, 08:15 PM

i need a BobCAD V23 post processor for a t-2 controller, or if anyone has a sample program that i could use to have a post made it is greatly appreciated.

Thank you

CNCRim · #2 03-21-2010, 02:45 AM

you can check Bobcad web they have post library.... may have the one you looking for.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Post processor for Syntec 900 T Controller?	weaston	Post Processor Files	4	03-17-2011 01:06 AM
DX-32 controller post	Cellar Dweller	Post Processors for MC	2	01-06-2011 12:24 AM
Need post for Fanuc 0MC Controller	Bruce Griffing	Dolphin CADCAM	4	09-18-2009 03:55 AM
post for centroid controller	Americo	Post Processor Files	3	05-31-2008 08:30 PM
Post for WinCNC Controller 2.1	tgramel	WinCnc	2	03-31-2008 05:56 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)