Results 1 to 2 of 2

Thread: Mazatrol CAM-T2

  1. #1
    Registered
    Join Date
    Apr 2009
    Location
    usa
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Mazatrol CAM-T2

    Hi, I have a 20/40 VQC Mazak with a Mazatrol control. The Z axis tra-41a servo control board went bad. We replaced the board with a rebuilt board and everything seems fine except we get a fault code of 22 I am hoping someone out there has an answer, Mazak servicemen are extremely expensive around here, I would not mind paying except if it is some simple keystroke I would feel foolish. Thanks Bob

    Similar Threads:


  2. #2
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    20724
    Downloads
    0
    Uploads
    0

    Default

    Alarm 22:= Z axis detecting signal missed.
    Seems you still have an issue with the Z detection?
    Also try Mitsubishi support in Chicago.
    Al.

    CNC, Mechatronics Integration and Custom Machine Design (Skype Avail).

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed