- Need Help!- MAZAK HMC with M32 CONTROLLER
-
Member
MAZAK HMC with M32 CONTROLLER
DEAR ALL HELPING FRIENDs,
I hv a HMC with M32 control.
Its magzine not rotating & alarm 389= Magzine over droop alarm appear.
Pl help
Similar Threads:
-
-
Registered
Need Help! MAZAK HMC with M32 CONTROLLER
Hi,
Seems there is command for Magazine rotation, but no actual movement.
1) Magazine rotation is from Drive / Motor or Hydraulic? If Drive or Inverter / motor, which make Mitsubishi or Yaskawa or any other ?
2) Is there any slight movement of magazine? If not is the power cable of Magazine motor ok?
3) What is the status on Drive / Inverter?
Best Regards,
Girish
- Need Help!- MAZAK HMC with M32 CONTROLLER
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules