Could it be your moving the turret at the same time?
I JUST PURCHASED A MAZAK QT-10 ( 1996 T-PLUS CONTROLL ) AND I WOULD LIKE TO USE A BAR PULLER BUT I GET A ERROR WHEN I TELL THE MACHINE TO OPEN OR CLOSE THE COLLET. THE ERROR IS ILLEGAL M CODE.
DOES ANY BODY KNOW THE SOFTWARE CODE TO ENABLE THESE TWO M CODES
THANKS FOR ANY HELP YOU CAN GIVE.
PAUL
Similar Threads:
- Need Help!- Mazak QT10 Control T2
- mazak qt10 t2
- Problem- Mazak QT10
- Need Help!- Mazak QT10 T1
- Need Help!- MAZAK QT10 T-2
Could it be your moving the turret at the same time?
Check your electrical manual. I think it is parameter R49. I forget which bit of this parameter you have to change to allow auto chuck open/close.
Make sure you put an M5 in before the M6 line or the chuck will not open.
DEAR GREG,
Thank you very much!!! You were right R49 is the location to turn on a T-PLUS control. A freind of mine has QT-10 the same year as mine and he looked at the "R MACHINE CODE PAGE" and we found 6 differnces one being R49. So we changed R49 to "01001010" and now the open and close "M COMANDS" work.
Somebody ought to keep a log of these "UNDOCUMENTED MACHINE CONTROLS".
THANKS AGAIN!!!
PAUL WILCOX
MILWAUKEE
Figured I would chime in and add that this is the parameter for the 640T Fusion control as well. I just used it on my '99 QT250HP.
Thank heavens for this post, and google.
I know this post is old, but anyone try programming a bar puller on a new Mazak QTN350 Mazatrol fusion control? tried various methods, chuck wont open at m206
Try a just M06