eia restart problem on mazak nexus 640m mill

[Denis13]

when we restart a program in eia on a Mazak nexus 640m, we don't have a feed rate. The only feed rate is the manual feedrate and i am not sure where the machine is going. we restart at the tool change. any idea?

Similar Threads:

• mazak nexus 200 lathe - spindle problem - matrix control
• Problem with toolchange in Mazak Quickturn nexus II
• tool change position on a mazak nexus mill 640m
• center drill diameter developpement on mazak nexus 640m mill
• need post processor for mazak 640m nexus controller

[psychomill]

Post your code. .....

But anytime you restart a machine, you need certain codes read so that the machine will do what you want. No different than when you start a program from the top. In this case, you either have a G1(2/3) with no feed, a positioning commmand with no G0, or a G1(2/3) with no feed.