Hi guys
I have an old Mazak Megaturn vertical lathe with a T32-3 control. It is now tripping out with an E-Stop alarm when the X axis is moving. I have checked the diagnostic page for more info on the cause but it only shows an E-Stop alarm, no other info. I have been keeping an eye on the load monitor and its not spiking over 14% load so normal.
Would anyone have any ideas what to check for here?
Similar Threads:
Hi Stanislav
The x axis drive that is faulting is showing alarm 43. All other drives are showing E7.
Give me your mailadress
Gesendet von meinem SM-N910C mit Tapatalk
Hi there
We have checked the drive units. The X axis has alarm 43 on it, the other drives have E7. I have checked our drive manual and they show error codes up to 37, then it skips to 45. There is no description for 43.
Any help here would be much appreciated.
Regards
Jake
Last edited by jake_tb; 08-07-2017 at 02:31 PM.