Mazak SQT15-MSY (T-Plus Control)+ LNS QuickLoad Barfeeder

[GLENDOJON]

We had to replace the computer in our Mazak QuickTurn and we are now having problems with our barfeeder. We recovered all of our parameters except for the R I parameters which are apparently not backed up. Now itt will not finish the top-cut program. The bar gets loaded but the chuck will not close. We get an error code on the barfeeder that says it's waiting on the chuck close signal and it just sits there. It will eventually error out on the machine as a 245 - Barfeeder Malfunction. Any ideas on what parameters we may be missing? Nothing on the barfeeder has been changed so we are pretty sure the problem is with a parameter on the QuickTurn.

Similar Threads:

• Newbie- Mazak barfeeder problem
• Trouble using barfeeder with mazatrol T plus control
• Need Help!- Mazak Lathe SQT15 programing help
• Replacing 8" Kitigawa chuck with a 10" on Mazak SQT15
• Mazak SQT18MS/ LNS Quickload

[skywalker4]

I would give mazak a call, they are very helpful over the phone.800-677-8311.