What mounts to the area the red arrow is point to? When air is hooked up to the machine, there is air rushing out of this area. Not sure if a pressure gage mounts here or a sensor?
I may need some extra help to revive a QSH-10 Mazak lathe with a T-4 controller. The lathe was purchased at a auction then disassembled to repair the ball screw support bearing but was not reassembled or test for a few years. So far I have found the electrical and mechanical manuals but could use the operational manuals.
Anyone have the T-4 operating manual and programming manual?
Similar Threads:
Last edited by Shefron; 06-26-2017 at 05:37 PM.
What mounts to the area the red arrow is point to? When air is hooked up to the machine, there is air rushing out of this area. Not sure if a pressure gage mounts here or a sensor?