Initialisation at first
MAZAK Service, servotek.gmbh@gmail.com
G'day all,
I have recently purchase a multiplex 620 with T32/6 controller very cheap because it hadn't run for quite a while. I have finally had time to power it up and after fixing the problem with the monitor I get a system check error. I have all the codes and most of the manuals but no mention of this error. Any ideas???
Similar Threads:
Regards Bob
Initialisation at first
MAZAK Service, servotek.gmbh@gmail.com
Thanks for the reply. How can I do that?? I have no functions available at all. The screen just has "Mazak T32/6) then down the bottom is the error message. No user screen and no buttons work.
Regards Bob
Send me a picture of the monitor on
Servotek.gmbh@gmail.com
MAZAK Service, servotek.gmbh@gmail.com
Thanks Stan,
I have reinitialised and reinstalled the parameters manually as it wouldn't read the parameter disc (must be corrupted). I have it powering up but with some errors. I will check all the board jumpers tomorrow and a few other things and see what happens.
Thanks again mate
Regards Bob
Hi, send me a picture of the monitor after initial.
MAZAK Service, servotek.gmbh@gmail.com