Multiplex 620 error

[sudsy]

G'day all,
I have recently purchase a multiplex 620 with T32/6 controller very cheap because it hadn't run for quite a while. I have finally had time to power it up and after fixing the problem with the monitor I get a system check error. I have all the codes and most of the manuals but no mention of this error. Any ideas???

Similar Threads:

• Russiche berken multiplex 3mm dik
• Need Help!- MAZAK MULTIPLEX 410, Mazatrol T32-4, MFD-ERROR
• Newbie- Mazak Multiplex 420
• Need Help!- multiplex 6200y
• MULTIPLEX 420 Alarms

[mazak-user]

G'day all,
I have recently purchase a multiplex 620 with T32/6 controller very cheap because it hadn't run for quite a while. I have finally had time to power it up and after fixing the problem with the monitor I get a system check error. I have all the codes and most of the manuals but no mention of this error. Any ideas???

Initialisation at first


MAZAK Service, servotek.gmbh@gmail.com

[sudsy]

Thanks for the reply. How can I do that?? I have no functions available at all. The screen just has "Mazak T32/6) then down the bottom is the error message. No user screen and no buttons work.

[mazak-user]

Send me a picture of the monitor on

Servotek.gmbh@gmail.com

MAZAK Service, servotek.gmbh@gmail.com

[sudsy]

G'day Stan, these are the screen pics

[sudsy]

Thanks Stan,
I have reinitialised and reinstalled the parameters manually as it wouldn't read the parameter disc (must be corrupted). I have it powering up but with some errors. I will check all the board jumpers tomorrow and a few other things and see what happens.

Thanks again mate

[mazak-user]

Hi, send me a picture of the monitor after initial.

MAZAK Service, servotek.gmbh@gmail.com

[sudsy]

Hi, send me a picture of the monitor after initial.

MAZAK Service, servotek.gmbh@gmail.com

I will do that next time I have a bit of time to play with it Stan. might get a chance over the weekend.