we recently had a bit of excitement with our SQT18MS chip conveyor. it was only a small fire....
end result is that we have a new drive motor on the conveyor and some fresh wires on the switch. the issue that i'm seeing is that one one of the phases is missing from the machine.
it's a 7 pin connector and the pins are alphabetically labeled. the three legs of the current are pins A,B, and C and pin G is the ground. pin C is dead.
does anyone know which breaker this outlet (labeled H33/H34) is wired to? my next step seems to be to inspect that breaker and i either don't have it in the manuals i have or can't read 'em properly.
or, anyone experienced this before who can maybe save me from having to run the whole system through to figure it out?