Mazak VTC 41 with Mazatrol EIA contol

[crandalljclj]

Looking for someone that knows something about this control? Would like to DNC some large programs, but not sure if the option for DNC is turned on or where to look? We do not have the manual for this machine, And if the option is turned how do you run in DNC mode on this control?
Thanks
Jeff

Similar Threads:

• Mazak M-4 Mazatrol T2 and mazatrol Cam T2 operating manual in english
• Need Help!- Mazak QT-15 with Mazatrol T-2
• Mazak Mazatrol ?
• Mazak, Mazatrol T1
• mazak(mazatrol-m1)

[murrayclair]

You dont need DNC option to run a big program. All you need is a transfer software program on your PC and a cable to the ISO RS232 port and run the machine in Tape mode not memory.
You will need the parameter book to set the baud rate start and stop bits the same as on your PC software.

[trieucn]

Looking for someone that knows something about this control? Would like to DNC some large programs, but not sure if the option for DNC is turned on or where to look? We do not have the manual for this machine, And if the option is turned how do you run in DNC mode on this control?
Thanks
Jeff

Can you sell or give me data of page offset of Mazak VTC-41?
http://www.cnczone.com/forums/mazak-...030-mazak.html
My machine corrupt the data on this page and page parameter. I have a parameter table, but have not a offset table (from H [D] 00 to H [D] 99). I had to reload the parameter table.
My email: trieucn@gmail.com
I come from VietNam.
Thanks!