Part counter G code


Results 1 to 5 of 5

Thread: Part counter G code

  1. #1
    Registered
    Join Date
    Oct 2011
    Location
    USA
    Posts
    104
    Downloads
    0
    Uploads
    0

    Default Part counter G code

    Is there any way to program a part count in g code for an M-32 control or do you have to run a sub program to count?

    Similar Threads:


  2. #2
    Registered
    Join Date
    May 2004
    Location
    United States
    Posts
    4519
    Downloads
    0
    Uploads
    0

    Default

    M30 should trigger part counter, if I recall correctly. Have not done G-code on a Mazak since 2002.



  3. #3
    Registered
    Join Date
    Oct 2011
    Location
    USA
    Posts
    104
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by txcncman View Post
    M30 should trigger part counter, if I recall correctly. Have not done G-code on a Mazak since 2002.
    that's what i thought but for some reason it isn't.



  4. #4
    Registered
    Join Date
    May 2004
    Location
    United States
    Posts
    4519
    Downloads
    0
    Uploads
    0

    Default

    Hopefully someone current on Mazak will reply. It has been more than 6 years since I touched one and I do not have an documentation for Mazak codes available.



  5. #5
    Registered
    Join Date
    Feb 2007
    Location
    USA
    Posts
    198
    Downloads
    0
    Uploads
    0

    Default

    This is from memory and applies to Fusion and later controls, but it could work on m-32

    I think it's M198 and can use a few more words in the line, in G code. It is the g code version of the mazatrol end unit, which toggles continuous/single cycle, parts count yes/no and is tied into the mazatrol parts count display.

    I think the format and specifics can be found in a mazatrol eia programming manual?

    jim



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Part counter G code

Part counter G code