MAzatrol T32B Control
I'm trying to revamp a QuickTurn 8N thats been sitting for some time (Its full of rat droppings!!) I get the following error on startup:
Bus error
Error at or near $004C0D96
I've checked all connections and all seems to be OK. I suspect the problem is somewhere in the NC as the LEDs don't look OK. Another so-called tech worked on the mach before me and literally ran away, taking the manuals with him. Can anyone point me in the right direction.
Similar Threads:
What LED's are on on the MC116 board in the control?
How long did the machine sit before you turned it on. There is a good chance the batteries dies during power off. It will be tough to tell because the batteries recharge on power up so they may read fine right now. If the batteries died then you will probably have to reinitialize the control.
reinitialize the control.
reinitialize the control.
Hi On the subject I have a mazak qt25 with the same control and i replaced the batteries and loaded the parameters and they start coming up with ** instead of numbers, also i have a parameter error alarm # 44 Please help! Thanks Jim Thinnsen 714 6121480 jim@tntind.comOriginally Posted by onthebumper
Initialize the control to get rid of the ****. Changing batteries and reloading parameters is not enough in this case.
Not to appear dumb, I am a chess master! LOL
"Initializing" the control consists of doing what exactly?
Thanks again for your help!
Hi
Can you show me which the led is on or off ?
Thanks !
It is also dropping parameters and replacing them with ** how do I "initialize" the control? Thanks!!
Reply with Quote
