| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-13-2010, 09:02 AM
| ||||
| ||||
Good morning all I have a simple question about changing a post to add a tool list to the header of my programs, The rep was by last week and helped the mill guy's with a problem and did this for the mill post. So of course I needed it for the Lathes x14 Found the part in gen setting to change this but changing it made things worse of course I did not change the oring.post so back to it I went. Is there a easy # change or do I need to get the book. Thanks
__________________ IF ITS NOT BROKE YOUR NOT TRYING HARD ENOUGH Ashes to ashes , dust to dust , If it wasnt for Harleys the fast lane would rust. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- SurfCam Post -repeat tool header info | MMTechi | Surfcam | 12 | 07-01-2011 06:16 PM |
| Build Thread- Tool list | jeffliu2 | GibbsCAM | 4 | 11-10-2009 06:23 AM |
| required tool list | DIFF OVER | General Metalwork Discussion | 10 | 10-18-2009 09:50 PM |
| Need Help!- CAN POST COLLECT TOOL INFO AND ASSEMBLE IT AT HEADER? | PROGRAMERDAVE | Post Processor Files | 2 | 09-18-2009 04:42 PM |
| Tool List model | hernandez72 | CNCzone Club House | 0 | 09-24-2008 11:45 AM |
| | |
Linear Mode
