| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-07-2010, 10:28 PM
| |||
| |||
I'm running a straight forward engrave toolpath. It seems that the toolpath will not complete if a cut runs over previous cuts in the engrave pattern. What's the command to force the toolpath to complete it's route?  |
|
#2
02-08-2010, 12:59 PM
| |||
| |||
| Hi, perhaps you can try to make a regular contour toolpath instead of engraving toolpath - in the contour parameter menu you can select compensation type: OFF. Then the cutter should just follow the selected contour. Thomas |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toolpath | tomduyx | EdgeCam | 0 | 11-28-2009 08:54 AM |
| Need Help!- Toolpath | mopar499 | BobCad-Cam | 15 | 05-26-2009 08:34 AM |
| What toolpath to use? | dpark1 | Mastercam | 2 | 01-08-2009 08:53 PM |
| Newbie- toolpath in mcx | craig | Mastercam | 15 | 06-01-2008 02:58 AM |
| 3D toolpath help | Dfennell | BobCad-Cam | 2 | 02-03-2007 01:13 AM |
| | |
Linear Mode
