error message during rough flowline or contour

[George777]

During the process of choosing geometry to run a rough contour or flowline tool path I get the following message:

"check and drive stock to leave are identical, you may wish to adjust check stock by plus or minus cut tolerance for crisper tool motion near external sharp corners formed by check and drive geometry"

How do you adjust the check stock tolerances at this point in the process?

[Superman]

Consider this more of a "Warning" insted of an "Error"

This is letting you know that when machining the "Drive Surfaces", you may actually touch the "Check Surfaces"

Values for each of these selections is input on the Surface Parameter page after you have selected the desired surfaces

The Warning appears each time you go the regen the operation unless you select to not display future warnings for this session