Need Help!- 2D POCKETING

[CNC_BOB]

I am using X3 and would love to know how to make my endmill enter a pocket a specific location where there is already a thru hole so that I do not have to ramp or plunge into solid, thanks in advance

[thebowman]

Chain the point where your thru hole is first.

Chain your Contour like you usually do.

Under Lead In / Lead Out check the box that says Use Entry Point. If you want your endmill to exit at the same point check the box that says Use Exit Point.

[robert copeland]

I am using x4 what I did was created a point at the hole location and used helix as an entry and check the box with center on entry point and it started at the point

[CNC_BOB]

thanks for the quick reply, I will try it now