Need Help! forgot the file - CNCzone.com-The Largest Machinist Community on the net!

Stran · #1 12-03-2009, 10:20 PM

please read my previous post I forgot to attached the file with it...Thanks again.

chuy · #2 12-03-2009, 10:56 PM

if you want cut only to that point break your chain where the groove and the od meet and re-chain it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Forgot how to set homing	IQChallenged	Machines running Mach Software	2	12-15-2007 12:15 PM
I forgot how to use Mach3	jrslick22	Mach Software (ArtSoft software)	3	12-06-2007 01:27 AM
Forgot the password after locking	kaleem1	Mach Software (ArtSoft software)	3	07-16-2004 04:37 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)