| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-03-2009, 10:12 PM
| |||
| |||
Can someone help me with mastercam lathe program...I'am in the process of learning mastercam lathe.please see the file attached.I don't know why but my "Z" toolpath went pass the 1.251 when I posted.I am very greatful if someone can help me.....  |
|
#2
12-04-2009, 08:04 AM
| |||
| |||
| where is the file attached? |
|
#3
12-05-2009, 03:52 AM
| |||
| |||
|
__________________ www.cad2cam.net Programmer/ Certified Cam Instructor |
|
#5
12-05-2009, 05:03 PM
| |||
| |||
| sorry at the 1.251 point draw another line to the outside of the stock and include this in your chain this will stop and rough to this line. Steve www.cad2cam.net
__________________ www.cad2cam.net Programmer/ Certified Cam Instructor |
| Sponsored Links |
| |
|
#8
12-06-2009, 06:07 PM
| |||
| |||
| Stran, Steve is right on this one.you will have to draw a line from the 1.251 to the outside of the stock to get the tool to stop there. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mastercam Lathe? | MDISolutions | Mastercam | 5 | 01-02-2009 09:51 PM |
| Need help on Mastercam lathe V9 | Bob Z | Mastercam | 2 | 11-05-2007 07:23 PM |
| Mastercam V9 Lathe | LIVVY111 | General CAM Discussion | 1 | 09-27-2007 08:06 AM |
| Mastercam X Lathe setup | Davidimurray | Mastercam | 2 | 01-27-2007 03:29 PM |
| | |
Linear Mode
