Help - CNCzone.com-The Largest Machinist Community on the net!

chuy · #1 11-25-2009, 08:46 PM

Trying to figure out if I could make this part in a lathe and of so how would I go about programing it...It's a Mori with a y axis...

chuy · #2 12-07-2009, 11:57 PM

Originally Posted by chuy

Trying to figure out if I could make this part in a lathe and of so how would I go about programing it...It's a Mori with a y axis...

Okay I have everything working fine ,but the 2 bosses on side....I'm going to do this part on a multiaxis lathe with a Y axis, but I can't figure out what path to use....Can some one point me in the right direction?

Steve Arteman · #3 12-08-2009, 01:10 PM

Chuy,
Looks like rolldie would probably work for these. I will try to make sure.
look in the chooks for this.
Steve
www.cad2cam.net

chuy · #4 12-09-2009, 05:45 PM

Originally Posted by Steve Arteman

Chuy,
Looks like rolldie would probably work for these. I will try to make sure.
look in the chooks for this.
Steve
www.cad2cam.net

What does roll die do?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)