Can anyone help me with toolpaths for this???

[cloverfield333]

I'm trying to generate toolpaths for this part and the canopenertoolpath1.jpg is the top view of the part and toolpaths. the following pictures are the facing operation (the part is being cut from a 3/16" X 2" X 6" tool steel and it is .0718" thick), and next i'm cutting the pocket of the can opener. I'm trying to get rid of the circled material in canopener toolpath5.jpg. can anyone help me fix my toolpath so i can remove this material??? Also if someone help me adjust the amount and depth of cuts since this material is tool steel and decrease the feed and speed that would much obliged. This part is in MasterCam X3.

[schwinndk]

Try using pocket toolpath in stead of contur toolpath. Only use contur on the outside contur of the part, and use the pocket for the inside. This will rough out the material you illustrate in pic. 5.
Ajust the debth of cut in the parameter of the pocket toolpath. Otherwise it will rough all the material out in one go. Here you can ajust a finish cut as well. Hope this can help you out...

[cloverfield333]

I'm now having problems with the pocket toolpath. After i clicked on all of the edges it told me i needed to have a closed path and not an open one. Can you help me adjust the path so that it is closed???

[cloverfield333]

Also can someone help me with generating the outer toolpath the shape of the canopener??? The depth of the part is .0718 inches.

[Mike Mattera]

Trim the geometry, to close the boundary.

Mike Mattera

[cloverfield333]

I got the pocket to work. Now i just need help with getting the outer shape toolpath. Can anyone help me with the outer toolpath???

[cloverfield333]

here is the file:

[schwinndk]

That should be easy. Use the contur toolpath, and select the chain around the part and hit enter. (Select the lower chain on the part). This chain looks like it has the contur of the part you wish to have.

[cloverfield333]

I'm only getting a part of the chain when i did what you said:

Can you show me with pictures how do you select the chain around the part??? i selected the lower part and got this

[schwinndk]

Select C-PLANE and not 3D and try again.

[cloverfield333]

I'm trying C-Plane but i'm still having trouble.

[schwinndk]

Try select rough contur and select the whole part. Then define the max debth under the parameters and select a point on the bottom of the part. Mastercam should recognize the contur then.
If not, then you will have to trim the geometry, to close the boundary/chain here as well, like Mike Mattera says.
But I can´t see why it´s not selecting the whole chain from the pictures you show.