| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
11-01-2009, 05:26 PM
| |||
| |||
Is there a way to do this in X4. Apparently their was Mastercam X as it's mentioned in the book I'm reading. Can't seem to find a way to do it. I tried the "Simplify" tool and that didn't work no matter where I set the tolerance. Also looked at the C-hooks and couldn't find anything there either.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need A Quote- Take a look spline job | turboless | Employment Opportunity | 0 | 05-21-2009 10:04 PM |
| spline help,mc9.1 | GRANDPA | Mastercam | 10 | 03-10-2007 06:00 AM |
| lines-arcs vs spline problem | metlcutr55 | General CAM Discussion | 1 | 07-07-2006 10:16 AM |
| How do I create solids from lines? | HawainPand | BobCad-Cam | 2 | 09-12-2004 12:36 AM |
| Spline | scottsss | Autodesk Software (Autocad, Inventor etc) | 13 | 07-14-2003 10:30 PM |
| | |
Linear Mode
