X3 cursor problem

[pilsnerglass]

Hello just installed x3 on our other pc and having problems. Havent changed nothing just opend it up and found this problem. When i go to draw something and you select your point, it doesnt show you what your drawing till you hit ok..then it shows you what you have drawn. And its not letting me snap to the center? Sorry still new to all this. Installed x3 on another pc and it worked just fine was drawing parts 2 mins after install,the one with problems is on a vista pc. i dont know if thats a problem an made it do that or what. If any have any suggestions would love to hear em. thanks

[Matt Berube]

Vista is not a problem. Would like to hear about your video card...

[pilsnerglass]

Its same as the other pc running x3 with no problems

[Matt Berube]

Then the only other thing I could recommend is to go to Settings, Configuration, Screen Tab, and play with "disable hardware acceleration" and/or "disable front buffer". Often folks with troublesome video cards find relief with adjustments here.

[pilsnerglass]

Its not a video card issue as it runs fine on the same setup. It has to be a settings or configuration issue with x3

[cadcam]

What is the Video card on this and have you Run MC on it before?
What is the computer a Dell by chance with the stock Drivers?
I would update the drivers for the Card.