EOB between each line

[oc-knives]

Hello

I use Mastercam V9 for my programming and upload/down load to an Excel 510 cnc machining center with a Fanuc O-M control. When I send my programs back to the pc from the cnc there is EOB,s between each line.

How do I stop this?

Thanks for your help.

[Superman]

Mastecam is not the cause of this.

This is controlled by the data transfer software you use in the PC.

In recieve mode, you should disable " Add CR after LF (line feed) " or something similar

[JimBoyce]

If you use Mastercam to communicate (data transfer etc.), check the mastercam post file for what Superman describes.