Machining time estimate ? - CNCzone.com-The Largest Machinist Community on the net!

SScnc · #1 08-10-2009, 04:05 PM

I had found in MCX where it showed the estimated machining time and I don't remember where it was I found it.

Would one of you remind me where that's at ?

Thank you,

Steve

Superman · #2 08-10-2009, 05:19 PM

Time estimate

-Select the operations you want
-Backplot
-upper LH corner ( the blue double arrows ) pull down
-"Info" tab is the place to be

Steve

SScnc · #3 08-10-2009, 05:39 PM

EXCELLENT, THANK YOU !

I did the backplot thing a couple of times while looking for it but I didn't click the blue dbl arrows.

Thanks again, I really appreciate it,

Steve

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem- File property under Axis- machining time estimate	Zig	LinuxCNC (formerly EMC2)	7	07-31-2009 04:44 PM
Need Help!- V23 run time estimate?	cut more	BobCad-Cam	7	05-08-2009 01:40 PM
Beta Run time estimate	barbter	NCPlot G-Code editor / backplotter	1	05-30-2008 06:31 AM
dry run's time estimate ?	lepton	TurboCNC	1	07-02-2006 06:02 PM
operation time estimate in setup sheet ?	andy55	Mastercam	3	10-06-2005 12:14 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)