| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-28-2009, 02:14 PM
| |||
| |||
Ok, so I am building this simple 4th axis part. When I go to backplot, it shows the endmill goingin Way past the origin, to the positive x axis, to where it would run into my rotary table. Does anyone have any suggestions why?  |
|
#2
07-29-2009, 03:08 PM
| |||
| |||
| It looks like the pocket you have chained goes over the origin line in the X+ direction  |
|
#3
07-29-2009, 07:59 PM
| |||
| |||
| Yes it does, the problem is that the spindle is going 10" too far in the x axis when it is above the part. If you do a backplot, you will see how it goes way too far. |
|
#4
07-29-2009, 11:35 PM
| |||
| |||
| That didn't happen to me when I back plotted, all of the cuts around the part were contained within the pocket geometries, try posting out the program and see if the large X moves are in the G-code |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| converting a mastercam 9 file into a Solidworks file | Michael82 | Solidworks | 5 | 04-17-2009 01:14 PM |
| Problem- "wrong program data" when file transfer???? | spock | Bridgeport and Hardinge Mills | 2 | 07-28-2008 05:59 PM |
| whats new? | single phase | Hypermill | 2 | 08-02-2007 02:24 PM |
| whats wrong with my computer? | keebler303 | Computers and Networking | 6 | 11-29-2006 05:28 PM |
| Whats wrong with this freaking rectifier part II | Noah | General Electronics Discussion | 19 | 07-08-2004 08:41 PM |
| | |
Linear Mode
