| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-16-2009, 09:51 PM
| |||
| |||
I have X3, and when back-plotting a pocket it runs fine. However when I try to verify, the toolholder will be well off the piece. Sometimes when verifying, the workpiece will disappear as well as the toolholder. The plot will run through the program but I cannot see it.  |
|
#2
07-16-2009, 11:40 PM
| ||||
| ||||
I had the same problem when I went from a Quadro FX 1500 video card, to a 1700 & did not update driver's. Went to Nvidia's web site & got the most current one for my card & fixed the problem. Harold C. |
|
#3
07-18-2009, 09:20 PM
| ||||
| ||||
| I would say eather what Harold said or the video card it self.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
#4
07-19-2009, 01:36 AM
| ||||
| ||||
| Having a good Graphics Card is a prerequisite for CAD and CAM Software.
__________________ Toby D. "Imagination and Memory are but one thing, but for divers considerations have divers names" Schwarzwald (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) www.refractotech.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mcam 9.0 toolbars | knsmilk88 | Mastercam | 1 | 03-03-2009 09:34 PM |
| Mcam V9 question | manufan | Mastercam | 1 | 05-27-2008 09:07 PM |
| MCAM Lathe 101? | gearsoup | Mastercam | 6 | 06-30-2007 08:48 AM |
| mcam and romi mill post question | chrisryn | Post Processors for MC | 1 | 01-11-2007 04:58 PM |
| mcam?? | tsutt | Mastercam | 3 | 09-26-2005 12:03 PM |
| | |
Linear Mode
