Need help triming surface - CNCzone.com-The Largest Machinist Community on the net!

dpark1 · #1 06-16-2009, 08:00 AM

I am trying to trim the .380 rad on the attached part,but not having any luck,any suggestions?

weirdharold · #2 06-16-2009, 10:44 AM

I went to Create/Surface/Trim/To Curves & put the Construction View in the Right Side & it trimed. I forget this a lot. Old age setting in , I guess.

Harold C.

dpark1 · #3 06-16-2009, 11:53 AM

Thanks, that was exactly what I was wanting, I usually draw in Solidworks then import, but that wasnt an option today! Thank you for your help!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- MX3 SURFACE TO SURFACE TRIM	82rouled	Mastercam	1	05-18-2009 12:02 PM
Need Help!- Surface to Surface Filleting and Trimming	cowpoke	Mastercam	6	03-17-2009 08:42 AM
surface help	msn_jrd	Mastercam	0	11-19-2008 06:28 PM
cut from surface	Flankman	Musical Instrument Design & Construction	0	09-02-2008 06:49 PM
MDT 6 Surface Cut	djzepp	Autodesk Software (Autocad, Inventor etc)	0	04-10-2007 10:56 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)