Newbie Making the leap - CNCzone.com-The Largest Machinist Community on the net!

mbam · #1 06-04-2009, 10:59 AM

I think I am going to give up on Bobcad. Can someone reccomend a reseller for Mastercam? I'm in S Florida if that makes a differance.

Thanks!!

Matt Berube · #2 06-04-2009, 05:26 PM

Hi Marc,

There is a dealer locator on the Mastercam website. Apparently there is only one reseller for Florida... link below.

http://www.camtechfl.com/mastercam/

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Making A CNC	pbawesome	DIY-CNC Router Table Machines	2	02-09-2009 04:12 AM
Made a leap of faith	aji549	Plasma, EDM and other similar machine Project Log	1	11-08-2008 02:09 PM
Making M2	pekeX	General Metalwork Discussion	0	04-06-2007 07:47 AM
making an arc	keebler303	Bridgeport and Hardinge Mills	9	10-15-2006 01:40 PM
Taking the leap to a Cnc Plasma rig. Help me decide	Kanman	CNC Plasma and Waterjet Machines	7	10-13-2006 11:22 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)