LinkBack URL
About LinkBacks
If I remember the last time I touched X2 there should be a Configurations Setting. In there you will see a list on the left side, but I am not sure which one it is under.Originally Posted by fenix728
I hope this helps a little.
| | |
hi, guys can anyone please tellme how to set the auto save comand in master cam x3 i know for mastercam x it was Alt +A but it does not work the same with mastercam x3 thankyou for your help. i would appreciate any kind of input on that subject thanks .
If I remember the last time I touched X2 there should be a Configurations Setting. In there you will see a list on the left side, but I am not sure which one it is under.
I hope this helps a little.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
Configuration's As Toby said. Configuration's/ Files.
Harold C.
Very nice screen shot Harold. I remember the colors being a bit different though. White on the CAM side and Blue on the CAD side. Is this in the Configuration settings too?
X4 is definitely on the X-Mas List this year
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
THANK YOU guys very much, your help is greatly appreciated. thanks a lot.
Posting Permissions
| | |
