| | |
Is this safe to use? I noticed feed rates went through the roof where minimal material is being removed.
Is this worth digging into. I am just wondering what success/failure stories others have had using it. Tips appreciated. I am a bit afraid of using it since it looks like it may cause some unpredictable results.
Thanks.
Do a little Googling for HSM or High Speed Machining.
http://www.google.com/webhp?hl=en#hl...fp=9nKAxhopn7M
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
Posting Permissions
| | |
LinkBack URL
About LinkBacks
