Trim Toolpath help

[timmydabull]

i am trying to trim a toolpath for a part that is on an angle,funny thing is i have done trimming before but this time i cant get to work.

i have tried trimming in top,right front wcs and none of them will work.

any suggestions on what i may be missing?
thank you
tim

[timmydabull]

i got it,deleted the geometry defining the trim boundarys and reselected my wcs and graphic view to the same,created the boundary and trimmed while in the same plane and it worked.

must have created the boundary in wrong plane before.

[Superman]

Yes, there can be frustrating times trying to trim

whenever you get a "entities don't intersect" warning, always 1st check if you are trimming 2D or 3D, make it 2D

3D will give problems, unless the entities do intersect at a 3D point,
otherwise your TOP / FRONT / SIDE construction planes should cover most of the rest

[timmydabull]

yes it was in 3D,
thank you