.NC program question

[tobyaxis]

Originally Posted by laszlozoltan I called my friend in a shop that has 9.1 sp2 on a system on the floor; he called back and said he tried a few things but it doesn't work. I recall we were able to verify our hand written nc code in class on mastercam 7- that was 10 years ago- it would be nice to do that because my coding is very very rusty these days from disuse.

If your hand coding is rusty you can get back up to par with NC Plot.

www.ncplot.com

[Rekd]

Originally Posted by Boots No not confused here. I could put start at the beginning of the NC program above the % sign and that's all that was needed.

You can not do that with Mastercam.

The closest thing possible is RP. The next closest thing would be File/Converters/Ascii, and that's not going to give you much you can use. It also does not require START at the beginning of the file.

[laszlozoltan]

Originally Posted by tobyaxis If your hand coding is rusty you can get back up to par with NC Plot. www.ncplot.com

Thanks !

[tobyaxis]

Originally Posted by laszlozoltan Thanks !

Your welcome!