| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#25
03-19-2009, 02:57 PM
| ||||
| ||||
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng)  |
| Sponsored Links |
| |
|
#26
03-19-2009, 08:11 PM
| |||
| |||
| Cadcam and Tobyaxis, Thanks so much for all your help. Files weren't my problem- accidentally defaulting to the "High Speed" pocketing routine was my problem. Weird stuff would happen in the tight places (or more acurately, "not happen"). When I finally got back to "parallel spiral"... Life is good! I'm going to go for a run now and celebrate. Jeff |
|
#27
03-19-2009, 09:34 PM
| ||||
| ||||
__________________ Toby D. "Imagination and Memory are but one thing, but for divers considerations have divers names" Schwarzwald (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) www.refractotech.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- V22 - Islands Getting Mutilated in Pocketing Operation | DonW | BobCad-Cam | 11 | 03-01-2009 04:39 PM |
| help with pockets leaving islands | touser | Mastercam | 7 | 08-14-2007 05:30 PM |
| Engraving with Islands | TZ250 | Dolphin CADCAM | 1 | 06-28-2007 11:08 AM |
| Flood Coolant Containment (Deluxe Stand) | SarcasmOMatic | Tormach PCNC | 1 | 04-09-2007 11:16 PM |
| Chip containment | Cold Fusion | Bridgeport and Hardinge Mills | 4 | 10-12-2005 09:25 AM |
| | |
Linear Mode
