trak dpm 3 - CNCzone.com-The Largest Machinist Community on the net!

kscarsdale · #1 03-11-2009, 11:05 AM

I need some help with a trak dpm 3 i have mastercam and i am trying to post a program and send it to my machine, my machine does not recognize all of the commands what type of settings do i need to use in mastercam as far as machine type and other settings i might be missing to write a good program and send it to my machine. If anyone can help i would be very thankful.

tobyaxis · #2 03-11-2009, 11:19 AM

Originally Posted by kscarsdale

I need some help with a trak dpm 3 i have mastercam and i am trying to post a program and send it to my machine, my machine does not recognize all of the commands what type of settings do i need to use in mastercam as far as machine type and other settings i might be missing to write a good program and send it to my machine. If anyone can help i would be very thankful.

You need the right post processor for that machine. If you ask in the Mastercam Post area someone will help you edit a post.

http://www.cnczone.com/forums/post_processors_mc/

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- SWI Trak CNC 2	kiwiavi	General CNC (Mill and Lathe) Control Software (NC)	0	11-12-2008 04:31 AM
Newbie- EZ TRAK SX	jpboyt	Bridgeport and Hardinge Mills	5	02-08-2008 12:19 PM
EZ-TRAK DX help please	doctordemo	Bridgeport and Hardinge Mills	10	11-22-2007 11:07 PM
Ez Trak Sx Ii	tsj3949	Bridgeport and Hardinge Mills	2	08-27-2007 09:44 PM
ez-trak	rsbbmw	Bridgeport and Hardinge Mills	6	06-07-2007 03:08 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)