| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-08-2009, 03:55 PM
| |||
| |||
MastercamX is showing me 1,150 seconds (almost 20 min) to face off a 10 inch part at 400 CSS & .010 FPR. It seems to be a problem with CSS as the drill time is perfect using 500 rpm & .004 FPR. I've attached the mcx file if that helps.    |
|
#2
03-08-2009, 07:24 PM
| ||||
| ||||
| Here is what I found Sir.Not sure why you are getting different on your side.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
#3
03-08-2009, 08:42 PM
| |||
| |||
| Here's mine. I see you are displaying minutes & seconds. Do you know if Mastercam X should also be displaying like this or just seconds? |
|
#4
03-08-2009, 08:54 PM
| ||||
| ||||
| What version is that you are running? is that the Mastercam X and no later? Mine was X3 MU1
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
#5
03-08-2009, 09:35 PM
| |||
| |||
| Yes - it's just plain old Master X. |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- Prgram cycle times | Atlas_Too | General CNC (Mill and Lathe) Control Software (NC) | 0 | 12-15-2008 01:31 PM |
| increasing cycle times | thetrillionaire | Haas Mills | 6 | 04-09-2008 12:03 PM |
| Need help with Titanium cycle times!!! | HAMMER66 | General Metalwork Discussion | 7 | 02-18-2008 09:53 AM |
| Extracting cycle times from FANUC OT | swilly | Fanuc | 5 | 12-30-2006 05:19 PM |
| | |
Linear Mode
