LinkBack URL
About LinkBacks
It is just released and there are not allot that have it mostly beta testers. so it will be a little time before you will get an answer on this.
| | |
I see Mastercam for Solidworks is finally available.
Has anyone had a chance to use it in a production environment?
Is it pretty solid, or are there a lot of bugs?
Any thoughts on your impressions of it would be appreciated.
Thanks,
It is just released and there are not allot that have it mostly beta testers. so it will be a little time before you will get an answer on this.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming
bump.
Anyone used it yet?
What is it you want to know?
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming
Posting Permissions
| | |
