Need Help!- TOOL BAR FOR X3

[CNC_BOB]

hey guys
our IT guy loaded X3 for us but there was an error message that said, could not load TOOLBAR from X2, so I started building a new one and now the auto cursor bar and the GENERAL SELECTION ribbon bar are not lined up directly bellow my toolbar the way it used to be, what am I doing wrong? can anyone help
thanks

[Derek Goodwin]

Is the toolbar too crowded? can you close a few? grab a toolbar by clicking on the vertical line at the left side of each toolbar, move it to a new location or drag it into the graphics screen and click "close" to remove it all together.
You can reset defaults under customize in the settings menu.

[Mike Mattera]

I would uninstall and reinstall, but dont do the "Migrate From X2" when it asks. That doesn't always work very well.

Mike Mattera

[cadcam]

Follow mike I have seen this a fw time on the tech side. you can try a repair some time this will reinstall the tool bar. but you are better off doing a reinstall.