Looking to..

[Eritex Inc.]

I had to re install X2 mill level 3. I cannot find the setting to change from 360 small strait lines to make a circle...

What I want looks something like this...


G1 Z-.25 F10.
G2 X0. Y-1.25 I-1.25 J0. F50.
X-1.25 Y0. I0. J1.25
X0. Y1.25 I1.25 J0.
X1.25 Y0. I0. J-1.25
G1 Z-.15 F100.
G0 Z.25


What I keep getting looks like this...

X1.3481 Y-.0707 Z-.0008 F30.
X1.3426 Y-.1411 Z-.0017
X1.3334 Y-.2112 Z-.0025
X1.3205 Y-.2807 Z-.0033
X1.304 Y-.3494 Z-.0042
X1.2839 Y-.4172 Z-.005
X1.2603 Y-.4838 Z-.0058
X1.2333 Y-.5491 Z-.0067
X1.2029 Y-.6129 Z-.0075
X1.1691 Y-.675 Z-.0083
X1.1322 Y-.7353 Z-.0092
X1.0922 Y-.7935 Z-.01
X1.0491 Y-.8496 Z-.0108
X1.0032 Y-.9033 Z-.0117
X.9546 Y-.9546 Z-.0125
X.9033 Y-1.0032 Z-.0133

Please help, I am stuck

[Superman]

What operation are you using to generate NC code ?

if using
2D_contour with ramp ? select ramp options button and untick " Linearize Helixes"

if happening on all opeations
pull down "settings"-->machine definition manager-->edit control definitions-->Arc-->mill-->tick on "surport arcs in XY plane"