how to add stock using the vertify

[cob]

hellow to everyone hope everyone had a happy new year.
back at this AGAIN.
I got to know how to use different fixture offset but when I run it on the verify there is only one square of stock that the tools are machining on I would like to add say 3 squares of stock on the screen and make one g54, next g55, and the last g56 that way when I see tool1 it will go from g54, to g55, to g56, and then all the next tools would do the same can some tell if there is and how do I do it.

[sanjeevlj]

use the transformation in toolpath menu
there select the coordinate transformation
select incement as 1 start as 0
and remove any thing in the tranlate tab

then post the transformatino
it will do the post for three offset
54 55 56

try...

[cadcam]

if you want to have four cubes on the screen during varify you will need to make for Sold cubes or surface modles on a level were you want them. then convert them to STL and use this as your stock be a "file" stock in varify.

[cob]

Originally Posted by cadcam if you want to have four cubes on the screen during varify you will need to make for Sold cubes or surface modles on a level were you want them. then convert them to STL and use this as your stock be a "file" stock in varify.

yes this is what I want to do have four cubes on the screen , but I dont quite
understand the proceess how you explain it I know you made it sould simple but I am not at that level quite jet. but I would like to see one of those little sample videos you do , thats is it is not to much of your time and bother to you.
thanks for the help

[Mike Mattera]

Create a new level.
Draw the cubes where you want them to be (spaced as you need).
_You can use Solid or Surface Primatives to create blocks_
File - Save - File Type - STL
Save it to a place you know, with a name you'll remember.

In Verify, create stock by a File and pick your stl file.

Mike Mattera