| | |
COULD SOME ONE HELP ME WITH A MX3 POST FOR A EMX CONTROL FROM PROTOTRAK?
YES..I KNOW THE DEALER HAVES TO PROVIDE ME, I BEEN EXPENT A LONG TIME, ASKING THESE GUYS AND I DONT SEE WHEN THEY CAN HELP ME...
IN THE MEAN TIME MY MACHINE STILLS RUN IN MANUAL MODE...
I HAD THE POST FOR THE MX2, IT WAS WORKING GOOD, BUT WITH THE LAST MX3 UPDATE, DONT WORKS PROPERLY..
I ALREADY DID THE UPDATEPOST.DLL THING
Treavor should be able to get the right post worked out. or have him contact Cadcam Consulting services the next door dealer to them as they have one.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming
Posting Permissions
| | |
LinkBack URL
About LinkBacks
