how to input the chanfer tool

[cob]

hello again
I am trying to see how to use the chanfering
I machined this aluminuim square (4x4) and I am trying to do this chanfer around the outside of the part bassicaly I am tring to deburr it but give it a nice chanfer. I have this chanfer tool but I dont know how to input into mastercam. can someone please expain how do I input it into mastercam and also if I have to edit the tool what would I input in angle
this chanfering is pretty knew too me

[cadcam]

For starters review picking the new tool.

[Derek Goodwin]

I have a sample video on chamfer here, cursor down to 2D toolpath chamfer, I do it a little different from CAD/CAM, but there is always more than one way to do things
http://eapprentice.net/index.php?opt...d=56&Itemid=71

[cob]

thanks for posting some pictures it was pretty helpfull
and those videos are just insane they are pretty clearly and well explain
thanks again.
know since I got the outside if I was to a chanfer in a pocket say a 2X2 would I know pick the pocket. to do the chanfer.

[Derek Goodwin]

yes, just pick the chain, in the opposite direction from the outside, so that the cutter stays on the inside

[cob]

that was easy
thank you