help for 4 axis - CNCzone.com-The Largest Machinist Community on the net!

francois belang · #1 10-05-2008, 01:29 PM

Hi I am using mastercam on a techno isel and trying to find someone to help on the 4axis instalation and software I am located in Davie Florida .my email is Robbel2@comcast.net

tobyaxis · #2 10-06-2008, 12:24 AM

First, have you tried to contact your Dealer?? They should have some ideas for you to at least get started.

You can also check the Emastercam Forum.

There is great literature on http://www.techedu.com/Mastercam_Books.asp

And don't forget to check out Mike's Tips for Manufacturing.com http://www.tipsformanufacturing.com/

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
the Difference of 2-Axis and 3-Axis of Vertical Mill Machine	begacon	Knee Vertical Mills	6	07-30-2009 07:31 AM
How can I coupling a stepper motor axis directly to other axis?	meknik2001	Stepper Motors and Drives	4	05-08-2008 02:54 PM
One axis (z-axis?) computer controlled testing device	TsThorsell	Stepper Motors and Drives	3	02-07-2008 01:38 PM
New Design - Hybrid 3-Axis Router/4-axis Foam Hot Wire Cutter	the__extreme	CNC Wood Router Project Log	3	02-26-2007 03:58 PM
Options for 2 Axis Head (to make 5 axis)	drewgarth	DIY-CNC Router Table Machines	6	07-12-2006 01:37 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)