Need Help!- Cant figure out how to do this part

[macona]

OK, This time I cant figure out how to do this part. The mcx file is attached.

Two sided part. Going to do the part in two vises. One vice does the fist side and the second does the other. First roughed with a 3 flute 1/2 corncob and then finished with a 1/2" finisher. In the first vise the part is milled down to slightly deeper than the main surface. Flipped and held by the edges in the next vise with soft jaws. SEcond surface and bosses are milled and holes are drilled.

Set up G54 and G55 in the WCS. But I cant get it to countour.


HELP!

-Jerry

[macona]

Think I finallg got it figured out. I couldnt get MC to fill n the arc on the two bosses to do the countour but it finally did. I will post my finished mess, err.. solution later.

[cadcam]

For one thought you do not need to models just one and here is a sample and I did a quick rough on both sides. you would need to do some finish contours and your holes but I gave you all you needed.