Post processor for HAAS and Fagor machine

[Namnp2007]

Hi all
We are need post processor for HAAS(model:TM-2), and Fagor( 8055model) machines. Pls. help us.
Thanks

[CJH]

If you have a post for any Haas machines in your library that came with Mastercam, then they should be able to be used with the TM-2. I'm not a Mastercam user as of yet, but probably will be in a few months when we get our new router. I know that with other CAM softwares the posts for the Haas are prestty much universal. I guess it would would only be a matter of setting up a template for the parameters of the TM-2 like the speeds and feeds.

CJH

[cadcam]

If you are in dire need you should be talking to Mastercam or your local dealer. as CJH said this post for the Haas comes on the Disk. this is a Tool room mini mill if I am correct a standard 3axis mill and that post out of the box will do the job.

You also did not post what version?

[cam1]

This one works very well, we use it on 3X VMC with mastercam V9
just rename it to use.

regards

[cadcam]

Cam1 that was nice of you but were is the rest of the post? being the Text file that goes with the PST.

Also be aware if this for Mastercam X or higher this will needed to be uptaded as this will not run as is in "X".

[cam1]

Hi cadcam: That is the post file that I use. I just renamed it to .txt in order to make it easier to up/download.
I wasn't aware that there was an accompanying .txt file that goes with a post file.
In any case the post I supplied works very well on it's own, provided you rename it to .pst.

regards

regards

[cadcam]

There usually a TXT that is named the same review a small portion of my V9 post dir.

[Namnp2007]

Dear CJH
Thanks for your reply.